TriStar Meters
Morningstar's TriStar Meter-2 (TS-M-2), TriStar Meter-2-600V (TS-M-2-600V) and the TriStar Remote Meter-2 (TS-RM-2) are advanced digital meters that may be used with the TriStar solar controller. These three meters are nearly identical except that the TS-M-2 and TS-M-2-600V are mounted on the controller and the TS-RM-2 is flush mounted up...
RSC-1
By converting to EIA-485, the RSC-1 allows up to 128 Morningstar products to communicate on the same communication bus and over much greater distances.
Meterbus Adaptor
Morningstar's PC Meterbus Adapter (MSC) converts a controller's meter port (RJ-11phone type connector) to a standard RS-232 serial connector for connection to a PC or other equipment. The MSC may be used with any Morningstar controller or inverter equipped with a meter connection that does not also have a RS-232 port.
Ground Fault Protection Devices
Morningstar's Ground Fault Protection Device (GFPD) family, models GFPD-150V and GFPD-600V, increases safety and design flexibility in off-grid photovoltaic (PV) systems. Ground fault protection is used in electrical systems to prevent current from following any unintended paths during a ground fault.
Relay Driver
Morningstar's Relay Driver is a logic module which provides high level system control functions such as high / low voltage alarms, load control and generator start. The product controls four independent relay driver outputs by reading digital data inputs
MeterHub
Morningstar's MeterHub allows multiple Morningstar products to communicate over a Meterbus network to provide improved data monitoring, additional capabilities and lower system cost.
Ethernet Meterbus Converter
The Ethernet MeterBus Converter (model: EMC-1) enables IP based network and internet connectivity to any Morningstar product that features an existing MeterBus port (RJ-11) including:
Remote Temperature Sensor
Morningstar’s Remote Temperature Sensor (RTS) provides improved battery charging in solar systems that experience temperature variations during the year. The RTS measures temperature at the battery and the controller uses this data for very accurate temperature compensation.
Steca
Solsum Regulators
Easy to use charge controller LED display Automatic battery voltage detection Full load protection Low self consumption Two sizes available - 6A and 8A
Steca PR Regulators
High End State of Charge control (SOC) Professional battery care Full grafical display Automatic battery voltage detection Full load protection Four sizes available - 10A, 15A, 20A and 30A
Steca Solarix Regulators
PRS1010 Regulator with LVD 12/24V 10A - No LCD
Studer
Studer VarioTrack MPPT Solar Charge Controller
Maximise the energy generated from solar panels by adding a VarioTrack solar charge controller with maximum power point tracker (MPPT) to any solar installation.The solar charge controller, VarioTrack, contains the MPPT algorithm that continuously tracks the maximum power point and automatically charges the batteries in an optimal way with all...
Studer VarioString Dual MPPT Solar Charge Controller
Dual MPPT solar charge controller:
Studer Battery Monitor
The SBM-02 is a highly accurate battery monitor. It is supplied together with a 500A/50mV shunt. This device is designed for 12 and 24V batteries. The optional voltage pre-scaler SBM-PS-02 extends the use of the SBM-02 to 27-175V batteries.
Pole Side Frames
Pole side mounts are a simple mounting solution for small area PV needs.
